Featured
2001 Suburban Reset Oil Change Light
2001 Suburban Reset Oil Change Light. Turn the ignition off and wait 10 seconds. 3 if the change oil soon light flashes 2 times, the system is reset.

Press and hold the set/reset (check mark) button on the dic , or the trip odometer reset stem if vehicle does not have dic buttons for more than 5 seconds. It is time to reset the oil life in my chevrolet suburban. Press the left arrow button then use up arrow to select info, then press the check mark button.
I Have Verified 12V On Large Orange Wire.
I recently changed the oil in my 1999 chevrolet silverado z71, but the change engine oil light in the message center of my dashboard is still on. Start the engine, if the change oil light is off you are done, if the change oil light flashes and then goes out turn the ignition of, wait and start the engine again. Turn the ignition off after displaying oil life message, then press and hold reset button.
To Reset The Oil Change Light, Follow These Two Steps:
Next, depress the accelerator pedal to the floor within the first five seconds of turning the key. To reset the change oil light, turn the ignition switch to the run position with the engine off. To reset the oil change light on my 2001 silverado, i turned the key to the on position, without starting the truck, and hit the gas pedal 3 times.
Press And Hold The Set/Reset (Check […]
The oil life will change to 100%. 1 turn the ignition key to the run position but do not start the engine. Does anyone know the procedure to reset the oil change light in a 2001 chevy truck (or suburban)?
To Reset The Change Oil Light In Your 2001 Chevrolet Suburban 2500 Try The Following:
If the light comes on and stays on for 5 seconds, the system did not reset. The change oil light should begin flashing. Press the left arrow button then use up arrow to select info, then press the check mark button.
Press And Hold The Set/Reset (Check Mark) Button On The Dic , Or The Trip Odometer Reset Stem If Vehicle Does Not Have Dic Buttons For More Than 5 Seconds.
I have less than 1v on the small orange wire but fluctuates to around 3v very briefly when i turn the ignition switch off or on. Could not tell which one it was. At this point, the instrument panel will illuminate.
Popular Posts
How To Change Audio Volume In Davinci Resolve
- Get link
- X
- Other Apps
Comments
Post a Comment